TNT switch setup

[Giordana]

How does one setup the TNT Switch?

[baobei]

I am sure it’s the 2nd switch.

[jordan]

Hi @baobei

Please see the following previous post, thanks!

Cutting my out when trying to connect wires

Hi @Regina47, Couple things: You can always right-click a crafting table to go back into piping mode to take another look at the wiring. You then jump 3x to exit back. In the TNT level, the button is (optionally) replaced with a switch so that you no longer have to hold the button down to turn any block into TNT. This also means that no new wires are needed. Also note that the switch has 3 pins, but only two of them receive wires. You can walk around in piping mode to get a better look. Than…